Outboard 10/20 Hour Check
Checked transom drain plug
Test run, check starter operation
Check idle speed and adjust if needed
Check warm-up throttle 1500-2000 rpm
Replace water separator fuel filter
Check and fill engine oil reservoir
Check throttle operation
Check engine mounting hardware
Run Salt-away through engine
Check and change gearlube and washers, check for water in lube, pressure and vacuum test if water found
Check overheat buzzer
Check water pump output and condition
Check steering and control cables, check total steering system ease of operation
Check hydraulic steering system
Check TNT and reservoir and fill, check tilt - free and easy, check shift
Check all safety functions
Spray powerhead with Corrosion Block
Perform audio and visual check, check overall condition
Check gauges
Check battery connections, replace battery wing nuts with locknuts
Check spare tire PSI
Check tire pressure PSI
Grease bearing buddies
Lube winch, coupler and tongue jack
Outboard Verado 300 Hour check
Check transom drain plug
Test run
Check compression
Check for proper operating temperature
Check and replace sparkplugs
Replace water separator fuel filter
Change engine oil and filter
Replace accessory belt
Set-up laptop and check and record
Run Salt-Away through engine
Check air filter
Check and change gear lube and washers, check for water, pressure & vacuum test if water found
Remove and check prop, check for fish line, grease shaft and replace prop with new pin
Replace water pump impeller
Check total steering system ease of operation
Check hydraulic steering system
Grease engine and steering cable
Check TNT and reservoir and fill as needed
Check trim and tilt
Check all safety features
Check boat accessories
Check all instruments and lights
Check for flat switch update
Check/replace anodes as needed
Check gauges
Check horn
Check bilge pump and float switch
Check, test and service battery, check fluid, charge if needed, replace wing nuts with lock nuts
Spin test trailer bearings
Check brake operation and fluid
Check tire pressure PSI
Grease bearing buddies
Lube winch, coupler and tongue jack
Trailer Service with Brakes
Check trailer and trailer lights
Spin test trailer bearings
Check brake operation
Check lock out solenoid
Check brake fluid
Inspect brake lines
Remove all drums, bearing and seals
Replace damaged parts as needed
Clean and inspect hubs and axle
Bleed brakes and check operation
Torque lug nuts/bolts to proper specifications
Check tire PSI
Grease bearing buddies
Lube winch, coupler and tongue jack
Trailer Service without Brakes
Check trailer and trailer lights
Spin test trailer bearings
Clean and inspect bearings and seals
Clean, repack or replace parts
Replace damaged parts as needed
Reassemble parts
Torque lug nuts/bolts to proper specifications
Check tire PSI
Grease budding bearings
Lube winch, coupler and tongue jack
Mark Corbett - Technician
Lighthouse Marine Inc.
5926 Sehmel Dr NW Bldg A, Gig Harbor WA 98332
We are an Authorized and Certified Dealer for:
Certified Yamaha 5-Star Dealer
Certified Mercuryand Mercruiser Dealer since 1988
Certified Bombardier - OMC, Johnson, Evinrude Dealer since 1988
Certified Volvo Service
Lighthouse Marine Inc.
Pleasurable Boating and Getting You Out on the Water Is Our Goal
5926 Sehmel Dr. NW Bldg A, Gig Harbor, WA 98332
Email: Lighthousemarineinc@gmail.com
253-858-7280 * 253-858-8160
Hours of Operation
May through August - Monday through Friday 8:00 am to 5:30 pm
Saturdays 9 am to noon - Closed on Sundays
September through April - Monday through Friday 8:30 am to 5:00 pm
Closed Saturday and Sunday
E-tec 300 Hour Service
Check transom drain plug
Check compression, test run and take download and note issues
Check charging, spark and cooling
Check and replace spark plugs
Sprayed decarbonizer through engine
Check fuel system for proper operation
Clean/replace fuel filters as needed
Replace water separator fuel filter
Check and fill engine oil reservoir
Run Salt-Away through engine
Check and change gear lube and washers
Check for water in lube, pressure and vacuum test if water found
Check speedometer pick-up
Replace exhaust back pressure nipple
Remove and check prop, check for fish line, grease shaft and install prop with new pin
Check water tube and powerhead restrictions
Replace water pump parts as needed
Check steering and control cables
Check total steering system ease of operation
Check hydraulic steering system grease engine and steering cable
Check tilt lock
Check TNT and reservoir, fill as needed
Check to see if tilt free and easy
Check all safety functions
Check shift
Spray powerhead with Corrosion Block
Check boat accessories
Check all instruments and lights
Check/replace anodes as needed
Check gauges, Check horn
Check bilge pump and float switch
Check, test, service and charge battery, replace wing nuts with lock nuts
Check trailer and trailer lights
Spin test trailer bearings
Check brake operation, check fluid
Check tire pressure PSI
Grease bearing buddies
Lube winch, coupler and tongue jack